Features:
- Normally-open relay action is provided on all sixteen output circuits
- Four isolated groups permit separate compatible load supplies
- Contact ratings cover both AC and DC switching applications
The IC660BBR101 catalog number selects normally-open contacts; it is electrically distinct in safe-state behavior from the BBR100 normally-closed block.
Four isolated relay banks give the control design flexibility to switch different AC or DC load sources from one Genius network device.
Contact life depends on current, voltage, inrush, power factor, switching rate, and suppression, so these values should be reviewed against the field load before installation.
The General Electric IC660BBR101 115/230 VAC 16-Circuit Normally-Open Relay Block is available for quotation, official documentation, configuration review, and system-matching support from Apter Power.
General Electric IC660BBR101 115/230 VAC 16-Circuit Normally-Open Relay Block Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
General Electric IC660BBR101 115/230 VAC 16-Circuit Normally-Open Relay Block Specs
General
- ManufacturerGeneral Electric
- ModelIC660BBR101
- ConditionNew Original ready stock
- Product FamilyGE Genius I/O
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Normally-open arrangement
- De-energized state: Every output contact is open when its relay is not energized.
- Group count: Sixteen contacts are divided into four banks of four.
- Source flexibility: Isolated groups may switch different compatible supplies.
- Logic indication: Circuit LEDs represent the relay coil state.
Field-load limits
- AC duty: Use loads within 5 to 250 VAC and the rated apparent power.
- DC duty: Use loads within 5 to 220 VDC and the rated wattage.
- Current rating: Limit each circuit to the specified 2 A maximum.
- Small loads: Maintain the recommended 10 mA minimum for dependable contact action.
Contact-life review
- Inrush: Measure startup current rather than relying only on steady-state current.
- Cycle rate: Keep inductive operation within 20 cycles per minute.
- Suppression: Fit appropriate components for coils or other stored-energy loads.
- Safe state: Test the process response with outputs commanded off and power removed.