Features:
- Consolidates thirty-two sinking outputs in one Series Three module.
- Accepts a 21.5 to 26.5 VDC field supply for compatible DC loads.
- Combines D-connector termination with LED output indication.
The 32-point layout adds output capacity without occupying another rack position.
A 0.5 A ceiling per channel makes load-current and inrush checks important during panel design.
Series Five systems can connect Series Three I/O through the designated interface when addressing and field wiring are planned together.
The General Electric IC630MDL356 Series Three 32-Point Sink Output Module may still be available for purchase and support from Apter Power beyond End-Of-Life (EOL) by the manufacturer (OEM).
General Electric IC630MDL356 Series Three Output Module Manuals,Datasheets,Link
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Command Behavior
- Point Density: Thirty-two controller outputs share one module position.
- Current Path: An active channel completes the load circuit toward DC common.
- Channel Limit: Each connected device must remain within the 0.5 A point rating.
- State Check: LED indication helps compare an output command with module response.
Field-Termination Details
- Interface: Field circuits leave the module through a D connector.
- Cable Assembly: The mating cable must preserve the specified pin assignment.
- Common Reference: Sinking loads require a consistent DC return path.
- Service Practice: Labeling the connector conductors reduces point-identification errors.
Reference Assignment
- Slot Position: The installed location determines where the output references are assigned.
- Program Access: Controller logic operates the channels through mapped output points.
- Documentation: Recorded rack and connector assignments simplify later troubleshooting.
- Replacement Check: A new module must retain the existing address and wiring relationship.
Installation Boundaries
- Native Platform: The module installs in a Series Three PLC I/O rack.
- Series Five Link: The specified Series Three I/O interface connects legacy racks to Series Five.
- Field Matching: Sinking polarity must agree with the connected 24 VDC devices.
- Commissioning: Rack assignment and connector pinout should be verified before outputs are enabled.