Features:
- Controls eight isolated current or voltage outputs.
- Selects ±10 V, 0–10 V, 0–20 mA, or 4–20 mA per channel.
- Updates all enabled channels within 8 ms.
Independent channel isolation helps separate field loops and reduces unwanted current paths.
Software range selection lets one module serve mixed analog actuator and setpoint requirements.
External 24 VDC field power is included in the cabinet power budget before commissioning.
General Electric IC695ALG808 PACSystems RX3i Eight-Channel Isolated Analog Output Module is available for quotation and official technical-file access.
General Electric IC695ALG808 PACSystems RX3i Eight-Channel Isolated Analog Output Module Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
IC695ALG808 Signal Range Setup
- Voltage service: Each channel selects bipolar or unipolar voltage operation.
- Current service: Each channel selects 0–20 mA or 4–20 mA.
- Mixed use: Voltage and current channels can coexist.
- Scaling: Engineering scaling is assigned independently.
IC695ALG808 Conversion and Update
- Full update: All channels refresh within 8 ms.
- Bipolar resolution: ±10 V uses 15-bit conversion.
- Current resolution: Both current ranges use 15-bit conversion.
- Unipolar resolution: 0–10 V uses 14-bit conversion.
IC695ALG808 Output Fault Response
- Hold mode: The last commanded value can be retained.
- Default mode: A configured value can be applied after faults.
- Channel enable: Unused channels may be disabled.
- Diagnostics: Module and channel status reach controller logic.
IC695ALG808 Field-Side Requirements
- Field supply: An external isolated 24 VDC source is required.
- Maximum load: Budget as much as 660 mA from field power.
- Backplane 3.3 V: The module draws 250 mA.
- Backplane 5 V: The module draws 17 mA.