Features:
- 32 MHz MC68040 processor
- 4MB shared DRAM
- Ethernet-only configuration
Motorola identifies MVME162-512A as an MVME162FX VME Embedded Controller for compatible embedded control systems. Its code identifies the 32 MHz, 4MB assembly with Ethernet fitted and SCSI omitted.
The documented ordering configuration combines 4MB DRAM with Ethernet and no SCSI. The Ethernet controller uses local-bus DMA, while four IndustryPack channels and VMEbus D64 support application-specific data movement.
Verify power, airflow, P1/P2 connections, serial settings, and transition hardware before installation. Confirm the Ethernet-only assembly, transition hardware, and every installed IndustryPack module against the official Motorola configuration before commissioning.
The Motorola VME MVME162-512A MVME162FX VME Embedded Controller is listed as Active / Available from OEM. Contact Apter Power for quotation, official documentation, and configuration review.
Motorola VME MVME162-512A MVME162FX VME Embedded Controller Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Motorola VME MVME162-512A MVME162FX VME Embedded Controller Specs
General
- ManufacturerMotorola VME
- ModelMVME162-512A
- ConditionNew Original ready stock
- Product FamilyMVME162FX 400/500 Series
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Onboard memory resources
- Main memory: 4MB shared DRAM
- Backup memory: 512KB SRAM with battery backup
- Firmware storage: 1MB Flash memory
- NVRAM / clock: 8K x 8 NVRAM with time-of-day clock
Communication and expansion resources
- Network: Ethernet interface with local-bus DMA
- Storage: No onboard SCSI interface
- Serial I/O: Two serial communication ports
- IndustryPack: Four IndustryPack ports
Chassis and commissioning checks
- Chassis: Use a compatible double-high VME chassis
- Backplane: Verify P1 and P2 connector requirements
- Serial I/O: Confirm serial-interface and transition-module settings
- Cooling: Provide forced-air cooling for the stated operating range