Features:
- RS-232 Modbus Serial communication for CompactLogix L1 and 1734 POINT I/O systems
- Configurable Modbus Master or Slave operation
- Controller-tag diagnostics and project-backed module configuration
Designed for point-to-point serial links, the ILX34-MBS232 places an RS-232 Modbus interface directly beside a CompactLogix L1 processor or within a distributed 1734 POINT I/O station.
Master and Slave operation are selected in the controller project, where the Add-On Instruction organizes I/O, status, control, and diagnostic tags. The module handles up to 1,000 words and as many as 30 configured Modbus commands.
A supported 1734-TB, 1734-TBS, 1734-TOP, or 1734-TOPS wiring base is required. Cable distance, baud rate, parity, node address, and the selected RTU or ASCII framing should match the connected RS-232 device.
Quotation and documentation support for the ProSoft ILX34-MBS232 Modbus Serial Module for CompactLogix L1 and POINT I/O Adapters is available through Apter Power.
ProSoft ILX34-MBS232 Modbus Serial Module for CompactLogix L1 and POINT I/O Adapters Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
ProSoft ILX34-MBS232 Modbus Serial Module for CompactLogix L1 and POINT I/O Adapters Specs
General
- Manufacturer ProSoft Technology
- Model ILX34-MBS232
- Condition New Original ready stock
- Product Family ILX34 In-Chassis Modules
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Supported serial protocol modes
- Framing: Modbus RTU and ASCII modes
- Device role: Master or Slave operation
- Node range: Node addresses 1 to 247
- Command set: Standard Modbus function codes support coil and register data exchange
Controller and POINT I/O integration
- Processor platform: CompactLogix L1 processors
- Distributed I/O: Distributed 1734 POINT I/O systems
- Engineering software: RSLogix 5000 or Studio 5000 configuration
- Project backup: Module configuration is retained in the CompactLogix project file
Wiring and commissioning checks
- Wiring base: Requires a supported 1734 wiring base
- Physical link: RS-232 point-to-point connection
- Commissioning check: Verify power and serial parameters before commissioning
- Distance limit: RS-232 point-to-point cable length is limited to 15.2 meters