Features:
- Four HART input channels with 4–20 mA process signals
- EtherNet/IP, Modbus TCP/IP, or DNP3 Ethernet integration
- Point-to-point and supported multidrop field-device operation
ProSoft PLX51-HART-4I connects HART-compatible process instruments to industrial Ethernet control and monitoring networks.
PLX51-HART-4I measures 0 to 22 mA on four inputs while exposing HART variables and device information through the selected Ethernet protocol.
Before wiring PLX51-HART-4I, verify loop power, channel polarity, device addresses, 247.5-ohm input impedance, Ethernet mode, DTM requirements, and the 12 to 28 VDC supply.
The ProSoft PLX51-HART-4I 4 Channel HART Input Module is available for quotation, official documentation, and application-matching support from Apter Power.
ProSoft PLX51-HART-4I 4 Channel HART Input Module Manuals, Datasheets, Links
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
ProSoft PLX51-HART-4I 4 Channel HART Input Module Specs
General
- ManufacturerProSoft Technology
- ModelPLX51-HART-4I
- ConditionNew Original ready stock
- Product FamilyPLX5x Gateways
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description. All prices are shown in USD.
Field-channel measurement resources
- HART Channels: 4 input channels.
- Input Range: 0 to 22 mA.
- ADC Resolution: 12 bit.
- Input Impedance: 247.5 ohms.
Supported Ethernet data paths
- Ethernet Connector: RJ45.
- Ethernet Rate: 10/100 Mbps.
- CIP Connections: 10 maximum.
- Modbus Function Codes: 1, 2, 3, and 4.
Network status and troubleshooting tools
- Calibrated Accuracy: Less than 0.15% at 25 °C.
- DNP3 Mode: Outstation.
- Operating Temperature: -20 to 70 °C.
- Power Requirements: 12 to 28 VDC.